Updated on April 19, 2022
How to Repair a Broken Garage Door Spring
One of the people’s most common questions when repairing their garage doors is “how to repair a broken garage door spring.” The answer varies depending on which part of the door is faulty. A broken garage gate spring is typically easy to spot, as it will often appear sagging. However, the break may be more subtle, and you might not notice it right away.

First, you should determine if you need to replace the whole spring or just replace one section. Torsion springs are made with several moving parts, and replacing them can be dangerous. It is best to hire a professional to perform this work, as several parts move and are under high pressure. It would help if you took the time to make sure you have the proper tools for the job. The following are some tips to help you fix a broken garage door spring:
To begin repairing your broken garage door spring, remove the center stationary torsion cones and winding bars from the garage door. Remove the springs from the bracket and measure the wire size, inside diameter, length, and orientation. Purchase a new spring with the same size, length, and winding orientation. When you replace the torsion, make sure you use the right tools for the job. If you don’t have the right tools, it may be best to hire a professional to do the job.
Once you’ve determined the spring size and type, you can remove the springs and fix it yourself. To replace the extension spring, open the garage door and clamp the ladders on each side. Once you’ve secured the brackets and removed the old spring, you can begin the replacement process. Once you’ve completed this step, you can now test your new spring and replace it with a new one. It is essential to take the time to check the entire mechanism before attempting the repair, since the broken part could be the cause of a larger problem.
While repairing a broken garage door spring can be a challenging project, it is important to follow the proper procedures. If the torsion spring is not the issue, you should contact a professional to inspect it. Otherwise, the problem could be something much worse. If you suspect a broken torsion spring, do not delay the repair. As soon as you notice the spring, it will be easier to find and fix the problem.
Using a ladder to reach the top of the garage door is a good way to save money. For a more complicated spring, you can use a pry bar to pull the spring out. Once you have the spring out, you can use a vice grip to clamp the other side. To do this, you will need to remove the winding bars and the center stationary torsion cones. Once you’ve accessed the torsion spring, you’ll need to carefully measure its inside diameter and the orientation of the winding.
The next step is to remove the garage door spring. To do this, you’ll need to remove the center stationary torsion cone and ladders. Before you can replace the spring, you must first inspect the entire garage door. In addition, the spring may be a symptom of another problem. In such a case, you must call a professional to repair the broken spring. It is important to have it checked by a professional to ensure safety.
A broken garage door spring can be difficult to diagnose. It is very possible that you’ve broken the spring and not realized it. It is best to hire a professional to replace the spring. Because the springs are pressurized, you need to be extremely careful to avoid any injury. If you’re not sure how to repair a garage door spring, it’s better to hire a professional. When it comes to repairing a broken spring, you need to use the right tools.